Using 2x4basics AnySize Table or Bench Sand and your 2x4's you can custom build a very sturdy picnic bench or low table coffee table side table or footrest up to 8 feet (2.4m). Versatile design makes the AnySize Table a good value for your outdoor furniture needs. You can store it as a side table or footrest and then use it as an extra bench when your seating requirements increase. Simple assembly with only a powered screwdriver and a saw. Only straight 90 degree cuts are required - no miters or angles. If you would like rounded corners a handy downloadable cutting template is provided on our website. All hardware is included. Made of durable and maintenance free structural resin the all-weather frame is built to last. The assembled unit stands 17 inches (433 mm) tall and 15 inches (381 mm) wide. You choose the length. Sand in color. By combining the AnySize Table with the Outdoor Dining Table AnySize Chair or Flip Top BenchTable you can create functional and attractive outdoor furniture groupings.

• Build your own low table side table or coffee table any size up to 8 feet using our AnySize Low Table kit and your 2x4's


• Assembly is simple.


• Made of durable maintenance free structural resin


• Includes 2 bench end supports hardware and assembly instructions (lumber not included)


• Lifetime warranty

More detail ...

Good idea good product

I just finished assembling a 2x4basics AnySize Bench 11200 and am very happy with it. The bench assembly took a little longer than I thought it would. I think I worked on it for about two hours. I wasn't counting on having to drill pilot holes for the dozens of screws (included) that had to be used putting the bench together. Nor did I figure on spending so much time figuring out how to best sink the screws into the underside of the boards. Don't worry about slanting the screws into the wood a bit. It is impossible to get a drill into a perfect position for making a 90 degree hole. Most of the screws do not show anyhow.



It was necessary to tip the bench over in order drill pilot holes and to get at the screws. I had to clamp the 2x4's to the plastic/composite ends to keep them from falling off or moving out of position. I would recommend using a couple of small carpentry clamps to hold things in place while putting the bench together.



I had the 2x4's sanded and painted prior to attaching them to the plastic/composite ends so that took a little time but probably not more than an additional hour. That probably saved time in the long run. Making this bench with the 2x4 basics kit is not a difficult project.



The 2x4 basics bench is solid and not all that heavy but it isn't going to blow over in a high wind. I am quite satisfied with how the bench came out and somewhat surprised at how substantial it is. I thought it might twist and perhaps wiggle side to side--nope it is a rock.



I am so pleased with this approach to building patio furniture that I will be recommending the product to friends.

More detail ...